Apply blue Loctite to the provided mounting screwsĢ Button Head Cap Screws - Provided for Vortex Viper and Venom SightsĢ Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights ![]() ![]() (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Place the red dot sight on the EGW Sight Mount Install the EGW Sight Mount on the slide Sig Sauer P322 Optics Ready (Need to remove the recoil lug to work) You can take our mount off and replace your rear sight at any time. Simply remove the sight plate on your gun and replace it with our mount in order to mount your Vortex Viper, Vortex Venom, Burris FastFire, or Docter red-dot sight. The EGW red dot sight mount adapter plates for the Sig Sauer P365 Optics Ready pistols are meant to be installed in place of the factory mounting plate. We would recommend either sending the red dot back for an exchange to whichever seller you purchased it from, or open up the holes in the bottom of the red dot to accommodate the pins. These dots may not fit properly on the posts on the plate. Please note: We have found that some red dots commonly found on Amazon such as the UTG and ADE may not hold the same tolerances as the red dots that this mount was initially created to work with. *All ADE mounts require 6-32 x 3/8" screws. 5 x 8mm Flat Head Screws - for mounting the plate to the slide - Requires use of 2mm Hex Key (2) 6-32 x 3/8" Flat Head Screws - Requires 5/64 Wrench or Driver No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.Ĭlick here to see a video from Vortex on how to install our red dot base on a slide.(2) 6-32 x 5/16" Button Head Screws - Requires 5/64 Wrench or Driver This product should be installed and checked by a qualified gunsmith. Modification of your firearm may nullify the manufacturer's warranty. The screws that are included with this mount require a 5/64'' allen wrench for installation. Install the EGW Sight Mount in the dovetail Red Dot Mounting Plate Installation Instructions ![]() Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight.
0 Comments
Leave a Reply. |